You are here

    • You are here:
    • Home > Support > Glossary beginning with S

 

Supported Device List
Glossary Index

S

S Band

The S band is part of the microwave band of the electromagnetic spectrum. It is defined by an IEEE standard for radio waves with frequencies that range from 2 to 4 GHz, crossing the conventional boundary between UHF and SHF at 3.0 GHz. The S band is used by weather radar, surface ship radar, and some communications satellites, especially those used by NASA to communicate with the Space Shuttle and the International Space Station. The 10-cm radar short-band ranges roughly from 1.55 to 5.2 GHz.

View Source: https://en.wikipedia.org/wiki/S_band

SAE J1708

SAE J1708 is a standard used for serial communications between ECUs on a heavy duty vehicle and also between a computer and the vehicle. With respect to Open System Interconnection model (OSI), J1708 defines the physical layer. Common higher layer protocols that operate on top of J1708 are SAE J1587 and SAE J1922. The protocol is maintained by SAE International.

View Source: https://en.wikipedia.org/wiki/SAE_J1708

SAE J1939

SAE J1939 is the vehicle bus recommended practice used for communication and diagnostics among vehicle components. Originating in the car and heavy-duty truck industry in the United States, it is now widely used in other parts of the world. SAE J1939 is used in the commercial vehicle area for communication throughout the vehicle, with the physical layer defined in ISO 11898. A different physical layer is used between the tractor and trailer, specified in ISO 11992.

View Source: https://en.wikipedia.org/wiki/SAE_J1939

SAE J1979

SAE standards documents on OBD-II: J1979 – Defines standards for diagnostic test modes

View Source: https://en.wikipedia.org/wiki/On-board_diagnostics#SAE_standards_documents_on_OBD-II

SBAS

Satellite-based augmentation system (SBAS) is a system that supports wide-area or regional augmentation to improve the navigation system's attributes, such as accuracy, reliability, and availability through the use of additional satellite-broadcast messages. Such systems are commonly composed of multiple ground stations, located at accurately-surveyed points. The ground stations take measurements of one or more of the GNSS satellites, the satellite signals, or other environmental factors which may impact the signal received by the users. Using these measurements, information messages are created and sent to one or more satellites for broadcast to the end users.

View Source: https://en.wikipedia.org/wiki/GNSS_augmentation

SBD

Short burst data - Special modems such as the 9522A, 9601, 9602 and Quake Q9612 can be used for sending and receiving short data bursts, less than 2 kilobytes at a time. This service is often used for asset tracking and remote monitoring. Messages are converted to be delivered in email format or over HTTP to a preconfigured address; the mobile unit does not include a destination address when sending a SBD message. A crude positioning report is also included in each message sent. SBD messages take from 6 to 22 seconds to send or receive. The latest generation of SBD transceiver, the Iridium 9602, can receive up to 270 bytes per SBD data message (defined by Iridium as "mobile terminated SBD") and can transmit a maximum of 340 bytes per SBD message (defined by Iridium as "mobile originated SBD"). A real-world example of the 9602 chipset in use is the YB Tracker.

View Source: https://iridium.com/products/IridiumSBD.aspx

SCADA

SCADA (supervisory control and data acquisition) is a system operating with coded signals over communication channels so as to provide control of remote equipment (using typically one communication channel per remote station). The control system may be combined with a data acquisition system by adding the use of coded signals over communication channels to acquire information about the status of the remote equipment for display or for recording functions. It is a type of industrial control system (ICS). Industrial control systems are computer-based systems that monitor and control industrial processes that exist in the physical world. SCADA systems historically distinguish themselves from other ICS systems by being large-scale processes that can include multiple sites, and large distances.

View Source: http://en.wikipedia.org/wiki/SCADA

SDK

A software development kit (SDK or "devkit") is typically a set of software development tools that allows the creation of applications for a certain software package, software framework, hardware platform, computer system, video game console, operating system, or similar development platform.

View Source: https://en.wikipedia.org/wiki/Software_development_kit

SHF

Super high frequency (SHF) is the ITU designation for radio frequencies (RF) in the range between 3 GHz and 30 GHz. This band of frequencies is also known as the centimetre band or centimetre wave as the wavelengths range from one to ten centimetres. These frequencies fall within the microwave band, so radio waves with these frequencies are called microwaves. The small wavelength of microwaves allows them to be directed in narrow beams by aperture antennas such as parabolic dishes, so they are used for point-to-point communication and data links and for radar. This frequency range is used for most radar transmitters, microwave ovens, wireless LANs, cell phones, satellite communication, microwave radio relay links, and numerous short range terrestrial data links. Wireless USB technology is anticipated to use approximately one-third of this spectrum.

View Source: https://en.wikipedia.org/wiki/Super_high_frequency

Short Burst Data

Short burst data - Special modems such as the 9522A, 9601, 9602 and Quake Q9612 can be used for sending and receiving short data bursts, less than 2 kilobytes at a time. This service is often used for asset tracking and remote monitoring. Messages are converted to be delivered in email format or over HTTP to a preconfigured address; the mobile unit does not include a destination address when sending a SBD message. A crude positioning report is also included in each message sent. SBD messages take from 6 to 22 seconds to send or receive. The latest generation of SBD transceiver, the Iridium 9602, can receive up to 270 bytes per SBD data message (defined by Iridium as "mobile terminated SBD") and can transmit a maximum of 340 bytes per SBD message (defined by Iridium as "mobile originated SBD"). A real-world example of the 9602 chipset in use is the YB Tracker.

View Source: https://iridium.com/products/IridiumSBD.aspx

SIM

A subscriber identity module or subscriber identification module (SIM) is an integrated circuit that is intended to securely store the international mobile subscriber identity (IMSI) and the related key used to identify and authenticate subscribers on mobile telephony devices (such as mobile phones and computers). SIM cards are designed to be transferrable between different mobile devices. A SIM card contains its unique serial number (ICCID), international mobile subscriber identity (IMSI), security authentication and ciphering information, temporary information related to the local network, a list of the services the user has access to and two passwords: a personal identification number (PIN) for ordinary use and a personal unblocking code (PUK) for PIN unlocking.

View Source: https://en.wikipedia.org/wiki/Subscriber_identity_module

SIP

The Session Initiation Protocol (SIP) is a communications protocol for signaling and controlling multimedia communication sessions. The most common applications of SIP are in Internet telephony for voice and video calls, as well as instant messaging all over Internet Protocol (IP) networks.

View Source: https://en.wikipedia.org/wiki/Session_Initiation_Protocol

SiRFstarV

SiRFstarV chips are capable of tracking NAVSTAR, GLONASS, Galileo, Compass, SBAS, and future GNSS signals. The SiRFusion platform integrates positioning from GNSS, terrestrial radio solutions such as Wi-Fi and cellular, and MEMS sensors including accelerometers, gyroscopes, and compasses. SiRFusion can then combine this real-time information with cellular base station and Wi-Fi access point location data, ephemeribased aiding information from the CSR Positioning Center (CPC) to generate accurate and reliable position updates.

View Source: https://en.wikipedia.org/wiki/SiRF

SMA

SMA (SubMiniature version A) connectors are semi-precision coaxial RF connectors developed in the 1960s as a minimal connector interface for coaxial cable with a screw type coupling mechanism. The connector has a 50 Ω impedance. It is designed for use from DC to 18 GHz.

View Source: https://en.wikipedia.org/wiki/SMA_connector

SMS

Short Message Service (SMS) is a text messaging service component of phone, Web, or mobile communication systems. It uses standardized communications protocols to allow fixed line or mobile phone devices to exchange short text messages.

View Source: https://en.wikipedia.org/wiki/Short_Message_Service

SNR

Signal-to-noise ratio (abbreviated SNR or S/N) is a measure used in science and engineering that compares the level of a desired signal to the level of background noise. It is defined as the ratio of signal power to the noise power, often expressed in decibels. A ratio higher than 1:1 (greater than 0 dB) indicates more signal than noise. While SNR is commonly quoted for electrical signals, it can be applied to any form of signal (such as isotope levels in an ice core or biochemical signaling between cells).

View Source: https://en.wikipedia.org/wiki/Signal-to-noise_ratio

SRID

A Spatial Reference System Identifier (SRID) is a unique value used to unambiguously identify projected, unprojected, and local spatial coordinate system definitions. These coordinate systems form the heart of all GIS applications. Virtually all major spatial vendors have created their own SRID implementation or refer to those of an authority, such as the European Petroleum Survey Group (EPSG).

View Source: https://en.wikipedia.org/wiki/SRID

SSAS

The Ship Security Alert System (SSAS) is part of the ISPS code and is a system that contributes to the International Maritime Organization's (IMO)'s efforts to strengthen maritime security and suppress acts of terrorism and piracy against shipping. The system is a IMO regulated system. In case of attempted piracy or terrorism, the ship's SSAS beacon can be activated, and appropriate law-enforcement or military forces can be dispatched. An SSAS beacon operates with similar principles to the aircraft transponder emergency code 7700.

View Source: https://en.wikipedia.org/wiki/Ship_Security_Alert_System

SSL

Secure Sockets Layer. It provides a secure connection between internet browsers and websites, allowing you to transmit private data online. Sites secured with SSL display a padlock in the browsers URL and possibly a green address bar if secured by an EV Certificate.

View Source: http://info.ssl.com/article.aspx?id=10241